Radiator Amp-10S Series
- Amp-10S is built
for the purpose to transmit the GPS satellite signal from outdoor to
indoor, and re-radiating the receptions for multi-users to operate GPS
inside buildings or vehicles.
- For L1 band
GPS signal, meets most of the GPS Receivers on the Market.
Plug-N-Play,easy to use
Wide range of Power
Input, compatible with any size of vehicle almost
radiation range could reach one meter around
simple of structure make as easy installation
L1 band GPS signal, meets most of the GPS Receivers on the Market
Amp-10S is a re-radiating equipment. It can receive the outdoor GPS satellite signal
and conduct to indoor place for radiating again. When a GPS Satellite is revolving
around the earth it will transmit continuously satellite signal to the earth, but the
strength of satellite signal will weaken to only around -125dBm when it arrived to the
earth ground. Such weak signal can't penetrate into buildings or vehicles; besides, its
reflection or scattering signal can be detected only in around windows area.
Amp-10S is built for the purpose to transmit the GPS satellite signal from outdoor
to indoor, and re-radiating the receptions for multi-users to operate GPS Receivers
inside buildings or vehicles. Therefore, users can work the GPSequipments indoor
same as using it outdoor.
Amp-10S contents a power regulation circuit, a high frequency low noise amplifier,
a signal radiation set, and an active outdoor antenna to receive the GPS satellite
Suggestion-- put the external Active antenna outdoors, better with no
To make the distance
for external active antenna and radar antenna as far as possible, too
close will cause oscillation.
The longer active
antenna cable be used, the higher gain it need.
Power Required: 10~26VDC, Less than 25mA, @12VDC input (Active Antenna
Frequency: L1 Band,
1575.42 +/- 10MHz
Red (For Power Input).
-40℃ ~ +80℃
5% ~ 95%
Dimension: 107 x
67 x 20 mm (Main Body)
Weight: 110 g
the length of Dipole are 6 cm the length of RG-174U Cable are 200 cm
Range: one meter around
MCX connector: providing
5V, 25mA power for the External Active Antenna
Antenna Impedance: 50 ohm
Gain: average 26dB need, for 2-5 meter cable, but it may depends on the
length of cable
1. Active Antenna
5 meters cable
5 meters cable
2. Power Supply for Indoors